Balboa Instruments Eco-matic ESC 36 Installation Manual download pdf (Page 41)

Water Flow

In most cases (for 1.5” and 2” PVC) the total water flow can

be directed through the Cell Housing as shown in Sketch

3a) without significantly affecting the flow rate and/or back-

pressure on the filter, etc. However, if flow rate is a concern

(high horse-power pump, large diameter piping, etc.), the

‘Cell’ can be installed on a by-pass (as shown in Sketch 3b).

Note the need for a valve to ensure a good flow of water

through the cell.

Helpful HINT

: When attaching the Cell Housing into the

pipework, attach the inlet and outlet pipes to the Cell

Housing FIRST – and then connect that assembly to the rest

of the pipework (Refer Sketch #2). The inlet and outlet pipes

should be pushed in, twisted, and held firmly in place until

the PVC solvent holds. Note: While making these joints,

hold the Cell Housing horizontally, with the inlet and outlet

pointing down, so that the liquid PVC solvent does not run

into the Cell Housing where it will look unsightly through the

clear plastic.

Helpful HINT: Copper Pipes? Use PVC ‘Flow-Lock’ fittings

(compression fittings) for easy connection of PVC to

copper pipes.

Cell Cord

Black

Blue

Black

Low Voltage

Raceway

Connecting the cell cord to the cell

1. Reinstall the cell back into the cell housing.

2. Install the BLUE connector from the cell power cord

onto the threaded bolt with the blue ring on the back of

the cell.

3. Install the two BLACK connectors from the cell power

cord onto the rods with the black fittings on the back of

the cell.

Connecting the cell to the system control center

1. Run the cell cord back to the System Control Center.

2. Connect the stripped wires of the cell cord to the 3-

position terminal block just inside the entrance of the

low-voltage raceway. The BLACK wires can be connected

to either terminal marked black. The BLUE wire is

connected to the terminal marked blue.

This completes installation of the chlorine cell. Important

information on initial operation of the chlorine generator will

be found in the start-up section in this manual.

Fig. 29 Chlorine Generator Cell Location in Plumbing

Fig. 30 Chlorine Cell Cord Wiring

Ball Valve

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 75 76

Comments to this Manuals

No comments

Balboa Instruments Eco-matic ESC 36 Installation Manual Page 41

Comments to this Manuals