Balboa Instruments Eco-matic ESC 36 Installation Manual download pdf (Page 23)

Mounting the System Control Center

IMPORTANT:

PLEASE READ THE FOLLOWING MOUNTING CON

SIDERATIONS BEFORE INSTALLING THE SYSTEM

CONTROL CENTER

The System Control Center is contained in a rainproof

enclosure. It is suitable for indoor or outdoor mounting. It

should mount on a flat vertical wall and MUST be positioned

so that the conduit knockouts are located at the bottom of

the enclosure. Also it is important that it is not mounted

in a confined space. The four sides need to remain free of

obstructions so that the system can dissipate heat from the

inside of the enclosure.

ATTENTION: POSITIONING THE ENCLOSURE WITH

THE KNOCKOUTS LOCATED AT THE SIDE OR TOP OF

THE ENCLOSURE MAY ALLOW WATER TO ENTER THE

SYSTEM AND CAUSE DAMAGE TO THE SYSTEM AND/OR

CREATE AN ELECTRICAL SHOCK HAZARD.

The System Control Center should be located as close as

possible to the pumps, heater, valves and sensors that are

required to be connected to it. Be sure that the system

and all other electrical components are at least 5’ (3m for

Canada) from the edge of the pool or spa. When selecting

the mounting position, plan how the 1” rigid conduit carrying

the power to the System Control Center will be routed. Also

plan for the routing of the flexible conduit that will run to

the pumps, lights and heater. Remember to consider the

length of the sensor wires & valve wires when selecting

the final location. The cell cord for the chlorine generator

is 10’ long, the cable length on the Air Temperature Sensor

is 10’ long and the Water Temperature Sensor is 25’ long.

They must reach connector receptacles located inside the

system. Additionally, the location selected should have clear

access in front of the system to permit the owner or service

personnel to stand in front of the System Control center

unobstructed by other equipment.

ATTENTION: BE SURE THE LOCATION CHOSEN FOR THE

SYSTEM CONTROL CENTER ALLOWS UNOBSTRUCTED

ACCESS TO THE GFCI PROTECTING THE UNDERWATER

LIGHT CIRCUIT. THE GFCI IS LOCATED ON THE RIGHT

SIDE OF THE BOX.

MOUNTING THE SYSTEM CONTROL CENTER

The Main System Control Center is a Permanently

Connected Control.

After selecting a location with the mounting

considerations (on this page), and any requirements

of national, state or local codes in mind, mount

the enclosure.

If the mounting substrate will allow, mount the System

Control Center by driving mounting screws through the

holes provided in the brackets at the top and the bottom

of the enclosure and into the wall.

If wall anchors must be used, hold the System Control Center

enclosure in position and mark the hole pattern on the wall.

Drill and set the anchors; fasten the enclosure with screws.

Be sure to position the Main Control Center level and square

for a neat installation.

After mounting the System Control Center, open the

enclosure door and remove the six screws securing the

interior cover to access the connections to the electrical

components. The enclosure door can be removed

for ease of wiring. To remove the door, open it wide

enough to clear the edge of the enclosure and then lift

straight up.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Comments to this Manuals

No comments

Balboa Instruments Eco-matic ESC 36 Installation Manual Page 23

Comments to this Manuals